Regulation Of Weights Lengths And Widths Of Commercial Motor Vehicles

Regulation Of Weights Lengths And Widths Of Commercial Motor Vehicles Book in PDF, ePub and Kindle version is available to download in english. Read online anytime anywhere directly from your device. Click on the download button below to get a free pdf file of Regulation Of Weights Lengths And Widths Of Commercial Motor Vehicles book. This book definitely worth reading, it is an incredibly well-written.

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles

Author : Transportation Research Board
Publisher : National Academies Press
Page : 283 pages
File Size : 53,6 Mb
Release : 2005-07-14
Category : Transportation
ISBN : 9780309077019

Get Book

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles by Transportation Research Board Pdf

TRB Special Report 267 - Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles recommends the creation of an independent public organization to evaluate the effects of truck traffic, pilot studies of new truck designs, and a change in federal law authorizing states to issue permits for operation of larger trucks on the Interstates. In 1991, Congress placed a freeze on maximum truck weights and dimensions. Some safety groups were protesting against the safety implications of increased truck size and weight, and the railroads were objecting to the introduction of vehicles they deemed to have an unfair advantage. Railroads, unlike trucking firms, must pay for the capital costs of their infrastructure. The railroads contend that large trucks do not pay sufficient taxes to compensate for the highway damage they cause and the environmental costs they generate. Although Congress apparently hoped it had placed a cap on maximum truck dimensions in 1991, such has not proven to be the case. Carriers operating under specific conditions have been able to seek and obtain special exceptions from the federal freeze by appealing directly to Congress (without any formal review of the possible consequences), thereby encouraging additional firms to seek similar exceptions. In the Transportation Equity Act for the 21st Century, Congress requested a TRB study to review federal policies on commercial vehicle dimensions. The committee that undertook the study that resulted in Special Report 267 found that regulatory analyses of the benefits and costs of changes in truck dimensions are hampered by a lack of information. Regulatory decisions on such matters will always entail a degree of risk and uncertainty, but the degree of uncertainty surrounding truck issues is uunusually high and unnecessary. The committee concluded that the uncertainty could be alleviated if procedures were established for carrying out a program oof basic and applied research, and if evaluation and monitoring were permanent components of the administration of trucking regulations. The committee recommended immediate changes in federal regulations that would allow for a federally supervised permit program. The program would permit the operation of vehicles heavier than would normally be allowed, provided that the changes applied only to vehicles with a maximum weight of 90,000 pounds, double trailer configurations with each trailer up to 33 feet, and an overall weight limit governed by the federal bridge formula. Moreover, enforcement of trucks operating under such a program should be strengthened, and the permits should require that users pay the costs they occasion. States should be free to choose whether to participate in the permit program. Those that elected to do so would be required to have in place a program of bridge management, safety monitoring, enforcement, and cost recovery, overseen by the federal government. The fundamental problem involved in evaluating proposals for changes in truck dimensions is that their effects can often only be estimated or modeled. The data available for estimating safety consequences in particular are inadequate and probably always will be. Thus, the committee that conducted this study concluded that the resulting analyses usually involve a high degree of uncertainty. What is needed is some way to evaluate potential changes through limited and carefully controlled trials, much as proposed new drugs are tested before being allowed in widespread use. The committee recommended that a new independent entity be created to work with private industry in evaluating new concepts and recommending changes to regulatory agencies. Limited pilot tests would be required, which would need to be carefully designed to avoid undue risks and ensure proper evaluation. Special vehicles could be allowed to operate under carefully controlled circumstances, just as oversize and overweight vehicles are allowed to operate under special permits in many states. Changes in federal laws and regulations would be required to allow states to issue such permits on an expanded network of highways, under the condition that a rigorous program of monitoring and evaluation be instituted.Special Report 269 Summary

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles

Author : National Research Council (U.S.). Transportation Research Board
Publisher : Unknown
Page : 270 pages
File Size : 45,5 Mb
Release : 2024-06-26
Category : Electronic
ISBN : OCLC:870328976

Get Book

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles by National Research Council (U.S.). Transportation Research Board Pdf

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles

Author : National Research Council (U.S.). Transportation Research Board
Publisher : Unknown
Page : 0 pages
File Size : 44,9 Mb
Release : 2002
Category : Electronic
ISBN : OCLC:932245186

Get Book

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles by National Research Council (U.S.). Transportation Research Board Pdf

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles

Author : Transportation Research Board
Publisher : National Academies Press
Page : 285 pages
File Size : 53,6 Mb
Release : 2005-07-14
Category : Transportation
ISBN : 9780309182874

Get Book

Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles by Transportation Research Board Pdf

TRB Special Report 267 - Regulation of Weights, Lengths, and Widths of Commercial Motor Vehicles recommends the creation of an independent public organization to evaluate the effects of truck traffic, pilot studies of new truck designs, and a change in federal law authorizing states to issue permits for operation of larger trucks on the Interstates. In 1991, Congress placed a freeze on maximum truck weights and dimensions. Some safety groups were protesting against the safety implications of increased truck size and weight, and the railroads were objecting to the introduction of vehicles they deemed to have an unfair advantage. Railroads, unlike trucking firms, must pay for the capital costs of their infrastructure. The railroads contend that large trucks do not pay sufficient taxes to compensate for the highway damage they cause and the environmental costs they generate. Although Congress apparently hoped it had placed a cap on maximum truck dimensions in 1991, such has not proven to be the case. Carriers operating under specific conditions have been able to seek and obtain special exceptions from the federal freeze by appealing directly to Congress (without any formal review of the possible consequences), thereby encouraging additional firms to seek similar exceptions. In the Transportation Equity Act for the 21st Century, Congress requested a TRB study to review federal policies on commercial vehicle dimensions. The committee that undertook the study that resulted in Special Report 267 found that regulatory analyses of the benefits and costs of changes in truck dimensions are hampered by a lack of information. Regulatory decisions on such matters will always entail a degree of risk and uncertainty, but the degree of uncertainty surrounding truck issues is uunusually high and unnecessary. The committee concluded that the uncertainty could be alleviated if procedures were established for carrying out a program oof basic and applied research, and if evaluation and monitoring were permanent components of the administration of trucking regulations. The committee recommended immediate changes in federal regulations that would allow for a federally supervised permit program. The program would permit the operation of vehicles heavier than would normally be allowed, provided that the changes applied only to vehicles with a maximum weight of 90,000 pounds, double trailer configurations with each trailer up to 33 feet, and an overall weight limit governed by the federal bridge formula. Moreover, enforcement of trucks operating under such a program should be strengthened, and the permits should require that users pay the costs they occasion. States should be free to choose whether to participate in the permit program. Those that elected to do so would be required to have in place a program of bridge management, safety monitoring, enforcement, and cost recovery, overseen by the federal government. The fundamental problem involved in evaluating proposals for changes in truck dimensions is that their effects can often only be estimated or modeled. The data available for estimating safety consequences in particular are inadequate and probably always will be. Thus, the committee that conducted this study concluded that the resulting analyses usually involve a high degree of uncertainty. What is needed is some way to evaluate potential changes through limited and carefully controlled trials, much as proposed new drugs are tested before being allowed in widespread use. The committee recommended that a new independent entity be created to work with private industry in evaluating new concepts and recommending changes to regulatory agencies. Limited pilot tests would be required, which would need to be carefully designed to avoid undue risks and ensure proper evaluation. Special vehicles could be allowed to operate under carefully controlled circumstances, just as oversize and overweight vehicles are allowed to operate under special permits in many states. Changes in federal laws and regulations would be required to allow states to issue such permits on an expanded network of highways, under the condition that a rigorous program of monitoring and evaluation be instituted.Special Report 269 Summary

Review of Canadian Experience with the Regulation of Large Commercial Motor Vehicles

Author : John H. F. Woodrooffe
Publisher : Transportation Research Board
Page : 137 pages
File Size : 41,5 Mb
Release : 2010
Category : Business & Economics
ISBN : 9780309155182

Get Book

Review of Canadian Experience with the Regulation of Large Commercial Motor Vehicles by John H. F. Woodrooffe Pdf

TRB's National Cooperative Highway Research Program (NCHRP) Report 671: Review of Canadian Experience with the Regulation of Large Commercial Motor Vehicles examines the process used in Canada to harmonize heavy truck size and weight regulations across the country. The report provides insights on how lessons learned from the Canadian experience might be applied in the United States.

Truck Weights and Lengths

Author : United States. Congress. House. Committee on Transportation and Infrastructure. Subcommittee on Highways and Transit
Publisher : Unknown
Page : 312 pages
File Size : 41,6 Mb
Release : 2008
Category : Technology & Engineering
ISBN : PSU:000066766049

Get Book

Truck Weights and Lengths by United States. Congress. House. Committee on Transportation and Infrastructure. Subcommittee on Highways and Transit Pdf

Federal Size Regulations for Commercial Motor Vehicles

Author : United States. Federal Highway Administration. Office of Freight Management and Operations
Publisher : Unknown
Page : 17 pages
File Size : 52,7 Mb
Release : 2004
Category : Commercial vehicles
ISBN : OCLC:526537634

Get Book

Federal Size Regulations for Commercial Motor Vehicles by United States. Federal Highway Administration. Office of Freight Management and Operations Pdf

New Trucks for Greater Productivity and Less Road Wear

Author : Anonim
Publisher : Transportation Research Board
Page : 248 pages
File Size : 49,8 Mb
Release : 1990
Category : Business & Economics
ISBN : 0309049636

Get Book

New Trucks for Greater Productivity and Less Road Wear by Anonim Pdf

TRB Special Report 227 - New Trucks for Greater Productivity and Less Road Wear: An Evaluation of the Turner Proposal evaluates the approach to regulation of the size and weight of trucks using U.S. roads known as the Turner Proposal. This approach had its origin in a proposal put forth in a 1984 address to AASHTO by former Federal Highway Administrator Francis C. Turner. The approach evaluated by the committee differs in an important respect from Turner's original concept: in the committee's approach, use of the new trucks would be voluntary; that is, truck operators would be offered the choice of continuing with existing equipment and weight rules or adopting the new trucks with the new weight regulations. The committee designed a package of changes in size and weight limits, safety restrictions, and procedures regarding bridge deficiencies, routing, and enforcement that would be a practical regulatory scheme for implementing the Turner concept. The committee recommends that every state, with careful assessment of the risks and uncertainties, consider this proposal as a supplement to current size and weight regulations. If Turner trucks were adopted in all states according to the recommended rules, they would reduce the cost of shipping freight and would not degrade safety. The total cost of maintaining the road system would be reduced, although pavement wear savings would be partially offset by higher bridge costs. The committee that carried out this study identified two truck configurations outside the weight and length limits established by federal law that would offer greater productivity without increasing infrastructure or safety costs. These vehicles formed the basis for the configurations recommended in a later (2002) TRB report, Special Report 267: Regulation of Weights, lengths, and Widths of Commercial Motor Vehicles.

Interstate Barriers to Truck Transportation

Author : United States. Bureau of Agricultural Economics,Margaret Ruth Purcell
Publisher : Unknown
Page : 126 pages
File Size : 46,5 Mb
Release : 1950
Category : Interstate commerce
ISBN : CORNELL:31924013695121

Get Book

Interstate Barriers to Truck Transportation by United States. Bureau of Agricultural Economics,Margaret Ruth Purcell Pdf

NCHRP Report 671

Author : Anonim
Publisher : Unknown
Page : 128 pages
File Size : 50,6 Mb
Release : 2010
Category : Electronic
ISBN : OCLC:1065691324

Get Book

NCHRP Report 671 by Anonim Pdf

Legal aspects of federal regulation of the sizes and weight of motor vehicles

Author : United States. Interstate Commerce Commission. Bureau of Motor Carriers
Publisher : Unknown
Page : 46 pages
File Size : 52,7 Mb
Release : 1940
Category : Transportation, Automotive
ISBN : UOM:39015024484076

Get Book

Legal aspects of federal regulation of the sizes and weight of motor vehicles by United States. Interstate Commerce Commission. Bureau of Motor Carriers Pdf

Freight Policy, Economics, and Logistics

Author : National Research Council (U.S.). Transportation Research Board
Publisher : Unknown
Page : 116 pages
File Size : 41,9 Mb
Release : 2003
Category : Freight and freightage
ISBN : UCLA:L0098570633

Get Book

Freight Policy, Economics, and Logistics by National Research Council (U.S.). Transportation Research Board Pdf

Motor Vehicle Size and Weight Regulations, Enforcement, and Permit Operations

Author : John Vince,National Research Council (É.-U.). Transportation Research Board
Publisher : Unknown
Page : 45 pages
File Size : 52,7 Mb
Release : 1980-12
Category : Electronic
ISBN : 0309030196

Get Book

Motor Vehicle Size and Weight Regulations, Enforcement, and Permit Operations by John Vince,National Research Council (É.-U.). Transportation Research Board Pdf

Vehicle Sizes and Weights Handbook

Author : J.J. Keller & Associates
Publisher : J.J. Keller & Associates
Page : 172 pages
File Size : 42,8 Mb
Release : 2008
Category : Motor vehicles
ISBN : 160287364X

Get Book

Vehicle Sizes and Weights Handbook by J.J. Keller & Associates Pdf

Organized by state and province, this convenient handbook contains an overview of needed size and weight information for all 50 states, plus Canadian jurisdictions. It provides practical tips for managing size and weight issues, and helps to determine lawful ways to configure vehicles.